1
General Mach Discussion / Need help urgently.
« on: May 04, 2017, 09:12:47 PM »
Hello, new here...
My main Mach 3 Computer Died, so i had to make a new Computer.
It is running Windows 7 home 32bit
dose not have a on board parallel port on board so I installed This one ( https://www.amazon.ca/gp/product/B001Q7X0Z8/ )
Here is my I/O Range, and ports and pins page.
http://i.imgur.com/mmhVIqY.png
I am unable to control my cnc, and I am all out of Ideas on how to fix this... Anyone see any glaring problems?
Thank you
My main Mach 3 Computer Died, so i had to make a new Computer.
It is running Windows 7 home 32bit
dose not have a on board parallel port on board so I installed This one ( https://www.amazon.ca/gp/product/B001Q7X0Z8/ )
Here is my I/O Range, and ports and pins page.
http://i.imgur.com/mmhVIqY.png
I am unable to control my cnc, and I am all out of Ideas on how to fix this... Anyone see any glaring problems?
Thank you