Guest
Show Posts
1
General Mach Discussion / Z axis trouble
« on: May 02, 2017, 03:38:20 PM »
Dear Mach3 community:
I run a 4'x8' ezRouter Scorpion. Am a newer user (5 mos) cutting out primarily profiles of shapes and letters in plastic. My Z axis has been acting up for the past month, and I don't know where I went wrong. This week's issue is: each time I load a G-code and click START, the Z axis LIMIT SWITCH immediately TRIGGERS - I don't know how to overcome this.
I run a 4'x8' ezRouter Scorpion. Am a newer user (5 mos) cutting out primarily profiles of shapes and letters in plastic. My Z axis has been acting up for the past month, and I don't know where I went wrong. This week's issue is: each time I load a G-code and click START, the Z axis LIMIT SWITCH immediately TRIGGERS - I don't know how to overcome this.