Hello Guest it is November 29, 2021, 01:49:45 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - speedi2

Pages: 1
1
General Mach Discussion / inverted y x axis
« on: April 19, 2017, 11:21:10 AM »
Hi. Is there any way to invert axis from y to x cause that what happened on my cnc router. My short axle is  x but is should be y. Because of that every project i send to cnc have to be rotated by 90 degrees. Where should i look for fault.

Pages: 1