Hello Guest it is March 28, 2024, 09:53:48 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - metalrabbit

Pages: 1
1
Mach4 General Discussion / Mach 4 stops at line 19091
« on: April 06, 2017, 02:57:09 PM »
My first post,

I am using Mach4 Hobby to face a surface but the program cuts at line 19091
line 19090   X229.03 Y227.898
line 19091    X228.833 Y227.848 F2000
line 19092    X228.655 Y227.748

system is in mm/min

Not sure why this is happening, the home/estop/limit switches both hard and soft are all green. I hit the cycle start button and the servos make a little thud with no real movement. Gcode was made using SW/SolidCam with an FANUCMach post processor. No tool change command on this run.

ideas?

Thanks!

Pages: 1