1
G-Code, CAD, and CAM discussions / Autodesk > LazyCam > Gcode > Mach3 Plasma Circles are not cutting right
« on: March 31, 2017, 05:36:34 PM »Hello everyone!
I hope you all can help me out with a setup I have going on.
How I go about creating my circle via Autodesk AutoCAD 2017
I draw a circle 60.125"
Save as "AutoCAD R12/LT2 DXF(*dxf)"
Launch LazyCAM and open said file (*dxf)
I see the circle on my screen and process it to create the GCODE
launch MACH3 and upload Gcode
run a test and see that at 12-6o'clock and 9-3oclock is cutting straight instead of a curve like a circle should have...
anyone have any experience with this problem and a solution?
Regards,
Fernando