Topics

1

General Mach Discussion / I need use the motor brushless with 5 axis stepper card

« on: February 19, 2018, 01:58:43 PM »

hi, I need know if possible pilot the motor brushless with  5 axis stepper motor card :

2

Third party software and hardware support forums. / help!!! I need of wires ST-V2 (alias KK-01) breakborad and UC300ETH on micromil

« on: March 29, 2017, 01:46:24 PM »

hi.
I'm a newbie about cnc conversion, and I want begin now.. i have the st-V2 card breakboard and UC300ETH . I had try for wire them, but i not want burn before and ask you for help..
I need of wire among them with 3 motor nema 23HS8630B 3A, 3 driver DM542A , nad power supply 350w , 36V 9.7a A.
I think of use with mach3 software ?
Someone have a link or a schematic diagram of how to link all done ?
I hace make a little scheme , but it's incomplete and i not know if will can work..

any suggestion is welcome!!!