Hello Guest it is December 01, 2021, 08:44:22 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - JimFut

Pages: 1
1
General Mach Discussion / Waterjet Diagonal lines
« on: March 29, 2017, 06:03:07 AM »
Hi All,

Recently i encountered a problem when cutting diagonal lines.
First i tried to look if there were any hardware problems, some bearings were a little loose but nothing serious.
My second step was looking if the problem still occurred when using the axis separately.
This resulted in clean cuts.

The wavy pattern can be traced back to the tool path. Here you can see the "point" dance around the actual cutting line.

Does somebody have any idea how to solve this?

Thanks in advance,

Jim  

Pages: 1