Hello Guest it is March 29, 2024, 08:54:42 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - What!

Pages: 1
1
General Mach Discussion / trouble homing slaved axis
« on: March 28, 2017, 07:33:01 PM »
 Hello, I am attempting to update an old plasma table with MACH3 and I can't seem to get the Y and A (slaved) motors to move when homing. They both jog correctly, I did make sure that the home slaved together box in general configuration is not checked. I tried changing the DoButtons around and running them in edit button script and vb script editor as follows DoButton(24), RefCombination(10), and DoButton(22). This changed nothing, my z axis zero's and backs off as it should and then my Y axis moves with only the Y motor, touches the home switch and it acts like a limit switch shutting everything down. I did verify that the switches are wired correctly and the correct inputs are checked. I did save this into a file that was used in the vb script editor, not sure what else I can try, any suggestions would be greatly appreciated. Thanks in advance.

Pages: 1