Hello Guest it is March 28, 2024, 05:26:48 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - cwciwatch

Pages: 1
1
Mach4 General Discussion / Mach4 Shuts down when loading any g-code file.
« on: November 06, 2018, 10:41:14 PM »
I need some help, I installed mach 4 on an older xp PC. It installed fine, and starts. as soon as I try to load ANY g-code file it immediately force closes. I use the exact same setup on two other machines without trouble. I have tried everything I can think of. Clean install, service pack 3, latest MACH4, etc. It fails on mill and lathe profiles, mine and oem. The lathe functions, moves, can jog , etc...  Thank you very much


Pages: 1