Topics

1

General Mach Discussion / In table view it's on wrong side

« on: May 07, 2017, 08:50:52 PM »

When I mirror image in Inkscape and import to mach3
The code shows up out of my table view
How can I correct this
Thank you I am really new
My first machine and home built

2

Third party software and hardware support forums. / Erratic steppers

« on: March 23, 2017, 08:57:42 PM »

Hello
I had steppers wired to pulse and direction on drivers and was really erratic
Switched  pulse and direction to opposite and motor runs better but only in one direction
I have 4wire steppers and an M542 drivers
Any thoughts
Thank you

3

Third party software and hardware support forums. / USB Mkx IV controller

« on: March 08, 2017, 09:15:40 PM »

Hello
Does anyone have better wiring diagram than the manual provides
I am just  learning started by a home built now wiring
I need to know where to wire the limit switches into
I put the home in the x y z home pins but am lost as where the limits go
Thank you in advance
Any and all help is greatly appreciated