Topics

1

Mach4 General Discussion / Mach4+ESS / Homing Error- Motor Not Enabled

« on: March 06, 2023, 02:09:43 PM »

I must be missing something obvious... Setting up Mach4/ ESS.  Copied all the settings over from mach3. I can jog on all axes, limit switches fire appropriately when I jog too far. Everything seems good until I attempt to home the axes. I get the following error:
!!!!!!!ESS: Homing Prep FAILED for Axis 2 - ESS Motor 2 - MOTOR NOT ENABLED!!!!!!

I'm on Windows 10 Pro 64-bit, latest versions of Mach4 and ESS
Motors are set to home 2(Z), 0(X), 1(Y).
I have looked at the few other posts regarding this error, but nothing seems to fit my situation. 

If anyone can point me in the right direction, I'd be grateful!