1
Mach4 General Discussion / G76 threading cycle bug ?
« on: March 05, 2017, 05:43:58 PM »
Hi to all
i'm new to mach4 hobby, but i have a strange thing about..
when i try to make a g76 threading cycle (using canned cycle wizard), and i try to set the K parameter to "0", mach4 give me an error .. k value is invalid
If i try to set K from 1 to 4 mach accept this, but the manual report:
can someone try this and report me ?
Is a bug ?
Bye
Axel
i'm new to mach4 hobby, but i have a strange thing about..
when i try to make a g76 threading cycle (using canned cycle wizard), and i try to set the K parameter to "0", mach4 give me an error .. k value is invalid
If i try to set K from 1 to 4 mach accept this, but the manual report:
Quote
KāCutting method
K = 0: Flank in-feed constant volume removal for each pass
K = 1: Alternate flank in-feed constant volume removal for each pass
K = 2: Flank in-feed constant depth removal for each pass (each pass same as first pass)
K = 3: Alternate flank in-feed constant depth removal for each pass (each pass same as first pass)
can someone try this and report me ?
Is a bug ?
Bye
Axel