Hello Guest it is March 29, 2024, 03:39:36 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bhdh405

Pages: 1
1
General Mach Discussion / associating M codes to output points
« on: March 01, 2017, 03:14:00 PM »
trying to find a table that will allow me to associate an existing m code number to a output number so that when I write the machining file I can enter say m12 to turn on out put 2 and m13 to turn it off type of thing.    ???

I am still pretty new with the m and g codes so lets start simple and then go to complex
butch

Pages: 1