Hello Guest it is January 24, 2020, 08:34:48 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - brapar

Pages: 1
1
General Mach Discussion / z axis suddenly only travels in up direction
« on: February 27, 2017, 04:04:10 PM »
I either had a power failure or computer died while I was doing a cutting operation. The computer just turned off. When I turned it back on and loaded Mach 3 my z axis is now moving only up no matter which key I press. The screen is showing correct directions. There is no problem with x and y axis. It was all working fine before this incident.  

Pages: 1