Guest
Show Posts
1
General Mach Discussion / C10S BOB to HY DIV268N 5a Drivers
« on: February 26, 2017, 04:11:29 PM »
Hi to all
I am all new to CNC.
My build is:
1/2 " Aluminum Frame, Gantry and Z Axis Unit
1605 ballscrews 1100, 700 and Z 300mm.
Longs motors, NEMA 23 Steppers 472 OZ,
HY DIV268n 5a Drivers
C10S cnc4pc BoB
MW S_400_36 Power Supply 110vac 36v dc
External Power Supply 5v 3000 Ma ouput
Had a Savebase c5 5 axis Chinese BoB that ended up frying after an hour of tests, ordered another and burned that on equally.
Now Purchased a cnc4pc C10S BoB.
My problem is understanding whether I Pull up or Pull down jumpers and what pins go to what on the drivers.
On the Chinese BOB X,Y and Z pins had Pul, Dir, En and N for ground pin outs.
After searching and reading for more than a week on C10S BoB, I am totally lost. Some instructions say o Jump to Ground COM and others Jump to 5v COM pins.
And nowhere can I find how to connect the EN pins
One of my main concerns is connecting correctly the C10s and how to Out Pin Limit switches , Should they be NO or NC circuit.
I understand configuring Pins in Mach3 but ambiguous to Dir Active Low and Step Low.
I am very anxious to have all this setup work properly as it will permit me to share with other CNC'ers many wonderfull hours of passion.
Thank you for all the help anyone can give...
Rick
I am all new to CNC.
My build is:
1/2 " Aluminum Frame, Gantry and Z Axis Unit
1605 ballscrews 1100, 700 and Z 300mm.
Longs motors, NEMA 23 Steppers 472 OZ,
HY DIV268n 5a Drivers
C10S cnc4pc BoB
MW S_400_36 Power Supply 110vac 36v dc
External Power Supply 5v 3000 Ma ouput
Had a Savebase c5 5 axis Chinese BoB that ended up frying after an hour of tests, ordered another and burned that on equally.
Now Purchased a cnc4pc C10S BoB.
My problem is understanding whether I Pull up or Pull down jumpers and what pins go to what on the drivers.
On the Chinese BOB X,Y and Z pins had Pul, Dir, En and N for ground pin outs.
After searching and reading for more than a week on C10S BoB, I am totally lost. Some instructions say o Jump to Ground COM and others Jump to 5v COM pins.
And nowhere can I find how to connect the EN pins
One of my main concerns is connecting correctly the C10s and how to Out Pin Limit switches , Should they be NO or NC circuit.
I understand configuring Pins in Mach3 but ambiguous to Dir Active Low and Step Low.
I am very anxious to have all this setup work properly as it will permit me to share with other CNC'ers many wonderfull hours of passion.
Thank you for all the help anyone can give...
Rick