Topics

1

General Mach Discussion / Alternat way to setup tool probe mach3

« on: September 24, 2017, 12:16:01 PM »

My board dose not respond to touch prob pins.  Is there another way to bypas problem with board to get tool probe working?

2

General Mach Discussion / New controller

« on: July 09, 2017, 05:02:10 PM »

I changed out my controller.  Controller still lookin for uc 100 driver.  How can I correct this?

3

General Mach Discussion / Mac3 software

« on: March 08, 2017, 08:00:19 PM »

When I go to motor tuning and put velocity  data in.  When I tab to acceleration the velocity goes to zero.

Any suggestions?

4

General Mach Discussion / Need Mach3 help

« on: March 04, 2017, 03:23:10 PM »

I have mach3 installed and have had no success in motor movement, nor limit switches working, nor prob working.  Was limited to number of uploads.

5

General Mach Discussion / Mach3 safety switch wiring

« on: February 22, 2017, 08:55:31 PM »

I am using a N/O switch. One leg connected ground other leg connected to pin input pin 2.  Just. Testing one switch nothing happens.
Have inport pin one and pin is #2.   Active low.  Please advise where I am going wrong.

Thank you