Hello Guest it is March 28, 2024, 04:44:50 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Dave75

Pages: 1
1
General Mach Discussion / 1st setup, Mach3 not moving in right scale
« on: February 21, 2017, 09:48:28 PM »
I have setup Mach3 and completed the autocalibraton in the settings screen.  I have it dialed in and is pretty much accurate at 408 steps per unit.  When I try to cut a test such as the roadrunner file, it is only about the size a dime smaller.  Anyone got suggestions?

Pages: 1