Hello Guest it is March 18, 2024, 11:34:16 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Bucks

Pages: 1
1
I'm trying to pocket some text on a piece of formica, but as the cutter works along the piece the depth of cut is getting shallower & shallower, for example we're cutting to 0.6mm depth with 6 passes, the first few letters start cutting on the first pass, then the next few takes 2 passes before it starts cutting & so on until nearer the end it's taking 5 or 6 passes to even start cutting & sometimes not even touching the workpiece towards the end.  The work piece is about 6" in length.
I've gone over the work surface with a bottoming bit so it's not an uneven work surface,
Any ideas what the problem might be?
Sorry if this is a bit vague I'm pretty new to CNC

2
FAQs / Spindle not working
« on: February 19, 2017, 04:40:11 PM »
Hi guys, totally new to CNC & have just purchased a 3040 machine with 800w motor, I've spent all weekend getting it set up, but for the life of me can't get the spindle to work! Any ideas what the problem might be? I've attached a few photos to hopefully give you an idea of what I've done as I'm not very computer savvy.

Any help would be much appreciated as I'm just about getting to the end of my tether.


Pages: 1