Hello Guest it is March 29, 2024, 05:32:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - GPWoodGuy

Pages: 1
1
General Mach Discussion / Question on Xbox 360 Plug-In on Mach 3
« on: March 09, 2017, 02:42:01 PM »
Hi all -
I am a relatively new user to the CNC world and have recently completed the build of my CNC machine.  I have Mach3 installed and it is running very well.  I just added an Xbox 360 wireless controller (Lee Davis' Plug-in; Ver 2.4.1.0) and have most all the toggles/buttons mapped to the functions that I need.  The one function that I can't seem to find and need some help on is the "GOTO ZERO" button on the Run Screen (see below).  I use this function for repetitive start locations and would like it to be mapped to my "A" button on the game pad.  There does not appear to be a resident function in the dropdown selection box - unless its called something different - which is entirely possible and I'm not smart enough to figure it out.   :-\ 

Any help will be greatly appreciated.

Thanks!!

2
Mach4 General Discussion / Startup problem with Mach 4
« on: February 23, 2017, 07:00:38 PM »
I am trying to evaluate whether to get licensed for Mach 3 or Mach 4.  My setup is as follows: Desktop Athelon 2600 ATX; running Windows XP SP3; 2 GB Ram; Nvidia 6200 Video card; SmoothStepper ESS.  I currently have Mach 3 installed and running perfectly and wanted to check out Mach 4 before committing to a license. When I install Mach 4, the installation window pops up stating that the installation was successful, However, as soon as I launch it, I get a window that pops up as seen below.  Any ideas?  Thanks for all the help!

PS - I attached a jpg but can't see it in preview mode - I'm hoping that y'all can view it!

Pages: 1