Topics

1

General Mach Discussion / Configuration for Sherline Mill Metric

« on: February 10, 2017, 04:48:04 AM »

Hi all,

Has anybody successfully used Mach 3 to drive the Sherline Milling Machine? Able to share with me the configuration file? The XML file I downloaded off from ftp.machsupport.com/XMLs seem to have wrongly configured motor outputs and it is causing my machine to behave really strange.

Regards,
Aloysius

2

General Mach Discussion / Position Loss Issue

« on: February 10, 2017, 04:08:24 AM »

hi all,

What i've done so far to drive my metric Sherline mill is to install UC100 + Mach3 on my desktop and then used the XML file for sherline metric off the ftp.machsupport.com/XMLs but when I run test code to cut a simple profile such as a square I get very bad loss of position every cycle:

Anybody able to help me troubleshoot this issue? I'm helpless, and have disassembled the mill a number of times to check backlash and what not...

Regards

3

General Mach Discussion / Mach3 DriverTest Blue Screen of Death

« on: February 10, 2017, 03:31:57 AM »

Hi all,

When I attempt to run the Mach3 DriverTest, after the initializing process it goes into take over, freezes at 1s left and then it crashes with a blue screen of death saying Mach3.sys attempted to write to a read-only memory.

How do I solve this problem?

Regards,
Aloysius