Hello Guest it is July 20, 2019, 11:18:30 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - mirzabala

Pages: 1
1
General Mach Discussion / Drivers
« on: March 05, 2018, 11:19:08 AM »
During the operation these words were written"driver watchdog" in mach3.what is this?thanks

2
General Mach Discussion / change the coordinates
« on: April 07, 2017, 12:04:34 AM »
Hi,during the operations machine begins to change the cutting place and stops because of machine limit how  can l solve this problem,thanks

3
General Mach Discussion / too fast for pulleys...using max
« on: April 06, 2017, 02:45:11 AM »
Hi,during the operations these words are flashing "too fast for pulleys...using max"
how can l solve this issue?thanks

4
General Mach Discussion / switches
« on: March 26, 2017, 07:32:57 AM »
Hi,tell me please can l use one switch for homing and limiting at the same time?
thanks

5
General Mach Discussion / motors tuning
« on: February 13, 2017, 03:12:44 AM »
HI,l want to use SFU1604-3 model ballscrew with nema 34HS9840 motors.Please tell me steps per,velocity and acceleration.unit is mm.thanks

6
General Mach Discussion / About the motors
« on: February 05, 2017, 01:51:49 AM »
HI,l use 34hs9840 model motor.l want to know the maximum and minimum velocity per mm in motor calibration,l use mach 3.thanks

Pages: 1