Topics

1

PoKeys / PlasmaSens, Pokeys57cnc and Mach4 setup.

« on: September 25, 2019, 10:11:22 PM »

I'm having an issue with setting up PlasmaSens in Mach4. In the Plasma Screen Configuration Register setting I type in PoKeys_40329/PlasmaSens HV and get the following error, "The analog input device or register you entered does not exist!!". In Pokeys software I can see the sensor working under the EasySensors setup tab. In Mach4 Register Diagnostics I am unable to find PlasmaSens. I opened a ticket with PoLabs Support, but I was wondering if anyone else had run into the same issue.

2

Mach4 General Discussion / Lathe Tool Turret Change M6

« on: February 04, 2017, 05:26:33 PM »

Does anyone have a working lathe turret tool change macro they are willing to share? I'm new to LUA script and have no clue where to start with writing my own code.