1
Mach4 General Discussion / Cannot set Machine coordinates G54 to 0.00 in the offset tab!!
« on: April 30, 2017, 06:01:22 PM »
Under the fixture Tab in the fixture table, G54 is defaulting with a negative 0.5254. I have tried every combination and cannot get it to stay to 0. This is causing any project where I need to cut material 3/4" in the material, the machine already thinks it's a 1/2" down into the material. If anyone can explain to me to get G54 to stay at 0, I'd appreciate your help.
Thank you,
Mike
Thank you,
Mike