Hello Guest it is March 29, 2024, 08:25:08 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ymsio

Pages: 1
1
General Mach Discussion / Anyone use "Import DFX's" before?
« on: August 05, 2009, 10:43:14 PM »
I used Mach3 R1.84.000 before, "Import DFX's" is a really good function to me.
Could I take out this function from older mach3 to new version mach3?


Thanks.

2
General Mach Discussion / high speed problem...
« on: July 26, 2009, 09:23:39 PM »
Hi,

I have a problem is that when I tried to increase feedrate to 2000, the angles will become radians...



each x,y&z uses same size AC servo & ball-screw.

is any setting wrong? ???

Thanks.

G code as below:
(File a )
(Monday, July 27, 2009)
G90G80G49
G0 Z0.0000
G90.1
G0 Z0.0000
M5
M6T1
M3
S2000
G0 Z0.0000
G0 X16.8291 Y5.3868
M3
F300.000G1 Z-2.0000
F2000.000G1 X44.6850 Y5.3868
G1 X44.6850 Y38.5996
G1 X16.8291 Y38.5996
G1 X16.8291 Y5.3868
G0 Z0.0000
G0 X58.8161 Y44.1707
F300.000 G1 Z-2.0000
F2000.000 G2 X58.8161 Y44.1707 I71.2552 j44.1707
G0 Z0.0000
G0 X66.7554 Y74.1694
F300.000G1 Z-2.0000
F2000.000G1 X30.9714 Y68.8125
G1 X47.8991 Y93.8827
G1 X66.7554 Y74.1694
M5
G0 Z0.0000
G0 X0 Y0
M5M30

3
General Mach Discussion / write wizard syntax error.
« on: July 05, 2007, 08:41:08 PM »
when I try to input character, a syntax error occur... :-[
how to solve it?? ??? ???
my MACH3 is Version R2.0.081

Pages: 1