Guest
Show Posts
1
General Mach Discussion / only one of the Y motors is malfunctioning
« on: January 15, 2017, 09:36:29 AM »
Hello Guys,
I recently discovered this great forum and this is my first post here.
I have a CNC wood router with two synchronized Y axis motors. Each motor has its own driver but the signal cable for both is in parallel with each others.
The problem is vibrating and bad behavior of only one motor while the other is ok. I connected the drive of the malfunctioning motor to the the good motor and runs OK which means that the driver has no problem.
Could any one advise what to do please?
I recently discovered this great forum and this is my first post here.
I have a CNC wood router with two synchronized Y axis motors. Each motor has its own driver but the signal cable for both is in parallel with each others.
The problem is vibrating and bad behavior of only one motor while the other is ok. I connected the drive of the malfunctioning motor to the the good motor and runs OK which means that the driver has no problem.
Could any one advise what to do please?