1
SmoothStepper USB / Error using Smooth Stepper and Mach 3
« on: January 28, 2017, 12:32:21 PM »
Long story is I ran my sherline mill on an old comp that had printer cable. Ok now that one died and so loaded mach 3 on main comp, loaded software for Smooth Stepper ect ect.
Now the sherline mill with Mach 3 runs great after couple of hours of resetting things and doing motors to run smooth, until, I start the spindle then I get the following error and everything stops.
[imghttp://][/img]
Anyone tell me what I can do short of throwing things out the window...
thanks for your time
Jim
Now the sherline mill with Mach 3 runs great after couple of hours of resetting things and doing motors to run smooth, until, I start the spindle then I get the following error and everything stops.
[imghttp://][/img]
Anyone tell me what I can do short of throwing things out the window...
thanks for your time
Jim