Hello Guest it is November 29, 2023, 10:51:00 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - pczombie

Pages: 1
General Mach Discussion / Need some helping slaving!
« on: December 28, 2016, 03:07:49 PM »
Hi Guys,

Its my first time building a CNC and also using Mach3. I am trying to build a CNC foam cutter. which only has two axis both slaved. The Y and the Z.

So far I have managed to slave my Y axis fine. I am trying to slave my Z axis. So far it only moves in one direction and when I jog it the other way the numbers move on the DRO but not the motor. The motor seems to be trying to turn a few steps but stops. Any ideas?

From Michael

Pages: 1