1
Mach4 General Discussion / GO TO WORK ZERO - ERROR
« on: September 16, 2017, 06:10:14 PM »
Hi All,
I recently updated to MACH4 V 4.2.0.3481 and PMDX Plugin V.0.2.254.
Now when I hit the Go to Work Zero button in MACH4 I get the following message - "AXIS 3 COMMANDED WHILE DISABLED"
The machine does not move to work zero. Prior o updating to the above versions I had no issues running this command.
My Gcode files still run as expected.
Any suggestions to rectify this issue???
THANKS
Daryl
I recently updated to MACH4 V 4.2.0.3481 and PMDX Plugin V.0.2.254.
Now when I hit the Go to Work Zero button in MACH4 I get the following message - "AXIS 3 COMMANDED WHILE DISABLED"
The machine does not move to work zero. Prior o updating to the above versions I had no issues running this command.
My Gcode files still run as expected.
Any suggestions to rectify this issue???
THANKS
Daryl