Hello Guest it is November 30, 2021, 09:36:53 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - dixedanc

Pages: 1
1
Just getting a grip on G-code.  I'm finding that code I generate with the Fusion 360 post processor inserts a G54 at the beginning.  So if I try run a part with a saved G55, it won't use it, uses the G54 anyway.  Am I mising something?

Can I just delete the line with the G54 from the code. any reason not to?   
Does the code need to specify an offset? 
Won't it just default to G54 if I don't manually choose a different one in Mach?

2
General Mach Discussion / Router vs Mill display config?
« on: February 18, 2017, 04:28:01 PM »
On a router the conventional axis orientation is  (y - side to side) and (x - forward and back)  . I'd like to be able to configure Mach3 in this manner

If I switch the the pins in config, or the connectors on the Gecko, I can get it to jog in the correct manner with the arrow keys on the keyboard.  But on the screenset the X and Y DRO's are still reversed.  Is there any way to change that?

Alternately, is there a way to switch the output of the arrow keys on the computer?

If i have to I could just retrain my brain, but it seems Mach3 should support a conventional router setup.


Pages: 1