1
VB and the development of wizards / Help with a wizard
« on: January 24, 2017, 10:07:02 AM »
Hello everyone,
I'm looking for a wizard for mach3 turn which let me do a rectification of a piece.
What I'd need is to put the starter diameter of the piece, the final diameter and the mm of material taken away with each pass.
There is a similar wizard already in mach3, however after each pass the tool goes back (this is because it's a turn wizard); this doesn't work for me since it takes twice longer to finish the piece.
My question is: is it hard to make a wizard like this? Can I find someone who can do this?
Thanks for any eventual help!
I'm looking for a wizard for mach3 turn which let me do a rectification of a piece.
What I'd need is to put the starter diameter of the piece, the final diameter and the mm of material taken away with each pass.
There is a similar wizard already in mach3, however after each pass the tool goes back (this is because it's a turn wizard); this doesn't work for me since it takes twice longer to finish the piece.
My question is: is it hard to make a wizard like this? Can I find someone who can do this?
Thanks for any eventual help!