Hello Guest it is March 28, 2024, 12:59:42 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - dnicholas133

Pages: 1
1
General Mach Discussion / Another Feed rate velocity issue
« on: November 23, 2016, 09:35:58 PM »
Hi All,
After spending days looking through the forum I have finally joined to ask for help.
Normally you can find the answers with a decent hunt but this eludes me probably through terminology.
I have purchased a router from china, everything is running as intended at this stage other than feed rates.
I did use the USB that came with the machine and copied those files over my original install

In motor tuning velocity is set to 10002 for X & Y
Maximum speed i get is 2500 on GO
when i run code G1 Y1000 F2500 gets a feed rate of approx 1000
G1 X1000 F2500 gets around 600
This is replicated if entered in the MDI
If I go G1 Y25 F25 it takes about 60 seconds

If anyone could highlight where to look for the issue or some troubleshooting techniques it would be appreciated.
Hopefully I can start contributing as much as the rest of the folks around here now  :)
Many Thanks

Pages: 1