Guest
Show Posts
1
FAQs / G code OK, but cutter does weird things!
« on: November 16, 2016, 11:04:21 AM »
Hi there,
I seem to have two problems.
Firstly when I start cutting, the end mill comes in at an angle (see picture).
Also, only on two jobs, the end mill goes off the tool path (see picture).
Ref the first problem, someone else on this forum had the same problem and resolved it by adjusting the CV to angles >87 degrees. I have done this but with no luck.
The G code is OK as I have tried it on a friend`s machine.
Hope someone out there can help, as I need this to produce new products.
Thanks.
Nick
I seem to have two problems.
Firstly when I start cutting, the end mill comes in at an angle (see picture).
Also, only on two jobs, the end mill goes off the tool path (see picture).
Ref the first problem, someone else on this forum had the same problem and resolved it by adjusting the CV to angles >87 degrees. I have done this but with no luck.
The G code is OK as I have tried it on a friend`s machine.
Hope someone out there can help, as I need this to produce new products.
Thanks.
Nick