Topics

1

General Mach Discussion / Did not receive license file....

« on: November 07, 2016, 02:07:45 PM »

Hi,

A few days ago I purchased a license for mach3 but still have not received any email with license file!. I've sent 2 emails but no reply yet. No phone number on the website.

When can I expect the license file? I paid with PayPal: misjah@24mastering.com

Get back to me ASAP pls.

2

General Mach Discussion / Only partial toolpath after installing parallel driver....help :S

« on: November 05, 2016, 12:49:55 PM »

Hi Guys,

Hope somebody can help me with this. I searched the forum but didn't see any problem like mine...

I'm running demo mode of mach3. when i run it without the parallel driver installed mach3 works fine. g-code is loading and toolpath is generated perfectly. HOWEVER, as soon as i install the parallel driver and i load the same g-code the toolpath only shows a small section and when i scroll thru the g-code on program run page it seems to be "stuck" at random lines.

I assume this has nothing to do with it being demo version and more with a conflict? I have already tried another port address but this didnt help either....

anybody has an idea?. I ran out of ideas so any help is welcome!

cheers,

Mis.