Hello Guest it is March 29, 2024, 03:05:14 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - wswells

Pages: 1
1
HiCON Motion Controller / motor config problem with mach4 + Hicon
« on: February 26, 2017, 06:18:29 PM »
Mach4 build 4.2.0.3233
HiCON Integra 7766
HiCON Plug-in 2.01.47
Windows 10 pro/ dell optiplex 7010

Hello, first post for help with my mill build.
After install and setup of both program and plug-in, setting mapping and motors to:
X-0 = motor-0
Y-1 = motor-1
Z-2 = motor-2
B-4 = motor-4
Checked Boxes in motor config, set motor indexs and settings in HiCON.
Nothing I have tried will allow me to set steps and config in Mach4 motor config, the first 5 boxes are grayed out on every motor.
Any suggestions for what I'm missing?
Set-up a new profile with mach 6 axis and reconfigured everything, no change.

Thank,
Steve

Pages: 1