Guest
Show Posts
1
General Mach Discussion / Two issues... really slow and not starting carving at 0,0
« on: April 19, 2017, 12:32:39 PM »
Hi All
I have a Chinese origin machine, to get it operational I have re-wired the whole system, replaced a number of components and setup things from scratch.
I have no configuration information from the supplier, nor specifications of things like the ballscrews etc.
Despite this I've managed to get it working to a point, the issues still remaining are:
1. Whilst I have setup MACH3, and the system moves at a reasonable speed, when I send a simple g-code file the system moves at very slow rate.
2. I am missing how to specify where the job starts, (the job shows in the display table in the wrong spot, no matter how I change the output from Aspire)
I'm sure i've missed something basic, any guidance would be appreciated.
I have a Chinese origin machine, to get it operational I have re-wired the whole system, replaced a number of components and setup things from scratch.
I have no configuration information from the supplier, nor specifications of things like the ballscrews etc.
Despite this I've managed to get it working to a point, the issues still remaining are:
1. Whilst I have setup MACH3, and the system moves at a reasonable speed, when I send a simple g-code file the system moves at very slow rate.
2. I am missing how to specify where the job starts, (the job shows in the display table in the wrong spot, no matter how I change the output from Aspire)
I'm sure i've missed something basic, any guidance would be appreciated.