Hello Guest it is March 28, 2024, 07:05:13 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - camcut

Pages: 1
1
General Mach Discussion / Running 4th axis independently from xyz
« on: October 17, 2007, 05:05:25 AM »
Is there a way to run a fourth axis continuous and independently from xyz axis within the Mach environment?
At present I have a large motor running a slow turntable within the xyz envelope but I would like to
replace this with a smaller one and wondered if I could use a stepper motor.

Tom

2
I have just taken delivery of my router and need to learn G Coding quickly. I get an error in Mach3 when running g52 and G41 together. I have tried the cutter offset code on different lines without success. It works well if I only use G41 or only G52 but not together. I have placed an extract of the code below. Can someone put me in the right direction?

Tom

g90 g40
g52 g41p4 x36.235 y130
G1 ( code for lead in)

Pages: 1