Topics

1

General Mach Discussion / arrow Keys will not move x and y motors see more....... info

« on: November 25, 2019, 02:52:24 PM »

arrow Keys will not move x and y axis motors from the keyboard. motors do jump when first turned on. using the jog function with the tab  does move the x and y axis but only very slowly. no speed control. I have inserted the plug in in the plug in folder. and the other one in the folder
This is a cross fire plasma table using win 7 on a dell laptop computer.  Thanks for looking and helping.
no g-code function either.

2

General Mach Discussion / No communication between computer and controller box.

« on: December 06, 2016, 07:54:07 PM »

Hello this my first post  please help my hair is nearly gone.

No communication between computer and controller box.
win xp, installed mach3 and configured it. says driver installed correct.
pt port numbers are the same
hobby cnc control board with power supply  motors hum a little
nothing on the diagnostic board after hooked up. no safety switch readings.
how can i verify if the computer is communicating with the control box?

Any suggestions....??