Hello Guest it is March 28, 2024, 05:04:10 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - yukon cornelius

Pages: 1
1
General Mach Discussion / Mach3 demo wont unlock to full version
« on: November 12, 2016, 06:59:16 PM »
I have purchased a license and copied it to the mach3 program but the program did not unlock to the full version and is stuck in the demo mode. What did i do wrong here or is there something i didn't do?

2
General Mach Discussion / z axis reverse
« on: October 27, 2016, 01:25:53 AM »
is there a way to reverse the z axis direction? when we jog it, it does the opposite but only for z. our machine may be wired backwards.

3
General Mach Discussion / newbie with a problem
« on: October 25, 2016, 12:22:05 AM »
hi  there, i am new here and new to cnc. we acquired a homebuilt cnc and have been trying to get it working. it is had never been used after it was purchased from the original builder. it was built somewhere around 8 years ago. the builder is was killed in a car accident so I cannot get any help there. the builder sent papers with it with port numbers and such from where he tested it with kellyware. I could not get kellyware to download. mach 3seems to be the software I want to try so we downloaded it. we entered the configuration from the sheets provided and followed the tutorial but our motors will not jog or move  at all. there is a slight motion when I have restarted the computer so I believe it is not all dead. maybe configuration mistake? any help is appreciated.

Pages: 1