Guest
Show Posts
1
General Mach Discussion / Newbie needs help
« on: October 24, 2016, 10:29:11 AM »
Hello All!
I have been routing about 9 months without any real problems I couldn't figure out. Friday it happened on a VERY simple job. I tried setting up the file all over from scratch today and got the same result. Tried some different CV settings friday with no change. Any help would be greatly appreciated. these are 5'' squares with 4 round holes in them, It won't make anything correct! I'm thinking something small and stupid, like a setting, but I can't figure it out. You can see I tried changing the way it was routing conventional/climb, just had opposite reaction. Notice how crazy the holes are! 2 are perfectly wrong on each piece and 2 are completely wrong from hole to hole piece to piece.
I have been routing about 9 months without any real problems I couldn't figure out. Friday it happened on a VERY simple job. I tried setting up the file all over from scratch today and got the same result. Tried some different CV settings friday with no change. Any help would be greatly appreciated. these are 5'' squares with 4 round holes in them, It won't make anything correct! I'm thinking something small and stupid, like a setting, but I can't figure it out. You can see I tried changing the way it was routing conventional/climb, just had opposite reaction. Notice how crazy the holes are! 2 are perfectly wrong on each piece and 2 are completely wrong from hole to hole piece to piece.