Guest
Show Posts
1
Mach4 General Discussion / How to update Mach4 builds?
« on: October 19, 2016, 09:06:00 PM »
So I'm running Mach 4.2.0.2914 hobby with ESS plugin 186 with a CNCRoom MB2 BOB, and I'm having all sorts of troubles, from the probe function not working (G31 just sits there, while running from the probe screen disables Mach) to my spindle speed commands not functioning correctly (S command for RPM is not accurate, and isn't even consistent) to my machine being unable to move after a proximity sensor is tripped.
Of course, browsing these forums for the past few hours has left me with little to show for it, so I've come to the conclusion that perhaps my install, well, just didn't work proper.
So how do I fix the install for MACH 4? I'm thinking of trying the latest build release, but how do I do that without losing the settings I have for the smoothstepper? That's a lot of motor and pin configurations, and I'm getting frustrated at how long this is taking to work.
My profile is attached (from the Help -> Support -> Package Current Profile task) if it helps.
Of course, browsing these forums for the past few hours has left me with little to show for it, so I've come to the conclusion that perhaps my install, well, just didn't work proper.
So how do I fix the install for MACH 4? I'm thinking of trying the latest build release, but how do I do that without losing the settings I have for the smoothstepper? That's a lot of motor and pin configurations, and I'm getting frustrated at how long this is taking to work.
My profile is attached (from the Help -> Support -> Package Current Profile task) if it helps.