Hello Guest it is March 28, 2024, 11:06:38 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - gael

Pages: 1
1
Dear all,

My problem is the following:

It appears that when passing a circular interpolation in the format "G2 X Y I J", the interpolation center (I J) is always interpreted by mach3 as a relative coordinate and never as a an absolute coordinate. Even with the proper G90, X and Y are correctly interpreted as absolute coordinates while I and J are treated as relative coordinates.

What can be done to make Mach3 G-Code interpretation to fit with the norme?

Best regards,

Gaƫl

Pages: 1