Guest
Show Posts
1
General Mach Discussion / Slow Jog % not working
« on: October 13, 2016, 08:37:31 AM »
After installing a Pendant , the slow jog % do not work normally , and as the pendant are not always attached it's quite annoying
Removing the pendant and it's plug in do not help ? The % works fine with the pendant, but not without
Does anyone know if this slow jog % is in the XML file and if so "where" , or any good advice on restoring the slow Jog % to work as normally
Thanks
Mechman
Removing the pendant and it's plug in do not help ? The % works fine with the pendant, but not without
Does anyone know if this slow jog % is in the XML file and if so "where" , or any good advice on restoring the slow Jog % to work as normally
Thanks
Mechman