Hello Guest it is March 29, 2024, 06:10:09 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - MinusApex

Pages: 1
1
General Mach Discussion / For Tarus CM5P
« on: September 18, 2016, 06:15:00 PM »
Hello, Came across this software looking for alternative solution to retrofitting a new controller on a Tarus 5 axis Model CM5P. Is there any reason why this wouldn't work? Being that I am getting back into CNC and picked this up for a great deal what should be on the shopping list in order for Mach 4 to (possibly) work? Appreciate the feedback and open to ideas.

Thanks,
Bob

Pages: 1