Hello Guest it is March 28, 2024, 10:31:28 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - boskap

Pages: 1
1
PoKeys / Change Stepper to Servo
« on: October 26, 2017, 04:52:12 PM »
Hi
Is it Possible to change my StepperMotors  to this Servo with integrated Driver
http://www.jmc-motor.com/products.php?cid=249&id=162

How i must them Connect to the Pokeys57cnc ?
Settings ?

thx Peter

2
PoKeys / Emergency reset
« on: October 24, 2017, 02:19:54 PM »
Hi
With latest Polabs version an Firmware
Pokeys57cnc v1.2 sometime means that Emergeny Button is pressed
but i didnt have one and the in the Pulse engine the emergency is inverted

befor i have no problems
nothing else is changed

any idea or workaround

3
PoKeys / PWM Settings for Pokeys57CNC
« on: August 27, 2016, 03:10:53 AM »
Hi
First my english is not so good
Sorry

Mach3 Version latest
Pokeys57cnc V1.1
Pokeys Firmwar 4.2.6
Pokeys Plugin Version  2.0 (shown in mach3 start)


My Problem ist that the PWM Setting are working in Pokeys Software it self
When i move Slider for Pin17 the spindle goes from 6000 to 24000
all ok

but in mach3 the speed is alway the same at 6000
i setup the pokey plugin like ithe manual (https://www.poscope.com/wp-content/uploads/downloads/Pokeys/Manuals/PoKeys%20Pulse%20engine%20v2%20and%20Mach3%20plugin%20manual%20(6.3.2016).pdf)
page 24
pmw period 50khz
pin17 Fixed Duty Cycle in %
15%

when i set it to 100% it always runs with 24000
when i set 50 % it always run with 12000

but now response on the g-code or override from mach3

what is wrong
please help

Pages: 1