Hello Guest it is March 29, 2024, 08:36:53 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - damianmcaleenan

Pages: 1
1
General Mach Discussion / Newbie with a question on Z axis
« on: August 22, 2016, 04:15:53 PM »
Just new to the mach3 software, my problem is when in the middle of a program and want to go back to zero the Z axis drags across the work piece. My question is? Is there a way of putting the Z axis into a safe mode or homing first before X & Y axis move. 

Pages: 1