Hello Guest it is March 28, 2024, 09:00:17 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Esprit

Pages: 1
1
General Mach Discussion / change of axis direction
« on: August 20, 2016, 03:57:00 AM »
Go into Config. / Ports & Pins / Motor Outputs and change the Direction Low Active state for your X axis. This will reverse it's direction of travel.

X and Z axis travel the wrong way. Tried to do change this as above and yes have clicked accept but the travel direction does not change?

Any suggestions.

Pages: 1