1
Mach4 General Discussion / Modbus ASCII Support for Mach4?
« on: January 31, 2018, 10:31:56 PM »
I have a Hypertherm Powermax 65 plasma cutter with serial port interface, and Hypertherm uses Modbus ASCII protocol. For Mach3 I used a Modbus RTU to ASCII translator (built with Arduino) to establish the interface, as Mach3 does not support Modbus ASCII. Can anyone tell me if Mach4 supports Modbus ASCII protocol? I've yet to own a copy of Mach4 and I'm still thinking very hard about getting Mach4 license for it. Thanks!