Hello Guest it is December 04, 2021, 03:24:00 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - estes53

Pages: 1
1
General Mach Discussion / Need ArtSoft Mach3 tutorials offline
« on: October 02, 2016, 09:54:54 PM »
Need to be able to watch these in my shop where there is no wifi- http://www.machsupport.com/videos/
Can't find them on utube and unlike utube, there seems to be no way to copy them.
Any ideas?

Thanx, Alan

2
General Mach Discussion / Why did my keyboard manual control stop working?
« on: September 25, 2016, 09:30:06 AM »
Why did my keyboard manual control stop working?
It worked fine for a few weeks, then suddenly it is gone.
The key numbers are still saved and I even re-input all of them, with no luck.
Any ideas?

3
I got my spindle to turn on via Mach 3, but when it is on Mach 3 thinks it is off and vice versa.

No speed control, seems to be at full speed.

Any ideas?

Thanx, Alan

4
Am using a Chinese Bob shown here-
http://www.omc-stepperonline.com/images/cnc-breakout-board-st-v2_02.jpg

I can find all kinds of instruction for wiring a spindle with an inverter, but I am using a simple DC spindle, shown here-

https://dzevsq2emy08i.cloudfront.net/paperclip/technology_image_uploaded_images/24938/default/30416-01300WDCspindle.jpg?1400187119

It came with it's own speed control board, but it gives no indication of speed, so would like to control it thru mach 3 if possible.

Anyone done this and can tell me how or provide a wiring diagram?

Thanx, Alan


Pages: 1