1
General Mach Discussion / Windows 7 64b and uc100 Mach3 Plasma
« on: December 08, 2016, 01:26:20 PM »
Hello, I have a 3 axis system with 4 drive motors. X, Y, Z, and A slaved to the Y. I have it set up in Mach3. A is slaved to Y. Restarted Mach afterwords. I have had this setup operating on another computer until the computer quit working. I have another desktop hooked up now and just running on demo until I can get it working properly, then I will transfer the licence over.
I can get the x, z, to operate in both direction the Y will move both directions but I get no movement out of the Slaved "A" motor.
Any thoughts and suggestions would be greatly appreciated. Thank
I can get the x, z, to operate in both direction the Y will move both directions but I get no movement out of the Slaved "A" motor.
Any thoughts and suggestions would be greatly appreciated. Thank