Hello Guest it is March 28, 2024, 06:05:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Lfab

Pages: 1
1
Mach3 under Vista / plasma stop cuttings or doesnt start
« on: August 10, 2016, 04:54:14 PM »
so table was working fine until the computer hardrive crashed. blue screened on me and i had an extra computer with the purchase that the guy said used to run the table. it has the bob cad on it and he kept that one at the house because it was slower and said the new computer for the table is faster and doesnt lag. they are both dell brand.

im having trouble installing windows xp on the new computer again becuase i have no floppy disks and the xp bootable disks i make arents working

so i hook up the old computer and i can control everything the same. i load old gcodes ive used and it starts the first pierce hole and then stops.

ive changed tips
changed g-codes.
tried plasma cutter manually with the hand held
ive unplugged everything and plugged it back in

ive got it make a couple short cuts and the arc goes out
ive tried with thc on and off


the table is a 2013 bulltear 5x10 with blade runner espII power control
have a hypertherm 85
 using mach 3 version r3.043.067 licensed to bulltear.
use sheetcam to make gcodes
 have bobcad 21 and bobcad 28 and neither of the gcodes are working at the moment


Pages: 1